DC Gear Motor Small Low Speed 24V, Permanent Magnet Bracket, CW CCW Rotation - High Torsion, Ultra Quiet Operation, Ideal for Sport Control and Industrial Use (100rpm/min)

Item Type: DC Gear MotorModel: XD-42GA755Material: CopperOutput Shaft Size: Approx. 8 x 20mm / 0.3 x 0.8inInsulation Resistance: After the rated operation of the motor under normal temperature and humidity, when measuring the insulation resistance between the coil and the motor shell with a DC500V resistance meter, it does not exceed 20MΩInsulation Withstand Voltage: After the rated operation of the motor under normal temperature and humidity, 50Hz or 60Hz is applied between the coil shells for one minute, and the abnormality is 1500V.Temperature Rise: It is normal to install a gear box or equivalent heat sink and conduct rated operation under normal temperature and humidity by using the resistance to measure the temperature rise of the coil below 70℃Insulation Class: Class B(130℃)Operating Environment Temperature: Motor: -10~+40℃ (no icing)Use Environment Humidity: 85% or less (no condensation)CW/CCW: YesSpeed Adjusted: YesModel Voltage（DC/V） No-Load Speed (rpm/min) No-Load Current(A) Load Speed (rpm/min) Loading Moment（kgf·cm） Reduction Ratio（1:00） Power（W） XD-42GA755 24V 100 0.27 93 4.58 50 25 150 0.27 128 3.06 33 25 200 0.27 175 2.29 25 25 300 0.27 245 1.53 16.6 25 500 0.27 435 0.92 10 25 600 0.27 535 0.76 8.3 25 Notes: 1 Overload and Locked Rotor: When the motor is running, it generates heat due to the energy conversion that occurs inside the coil and the iron core, and the temperature gradually rises. The load is within the rated range, and the heat generation and heat dissipation are balanced, and the coil of the motor will not be burnt. However, it will cause heat under overload and locked-rotor conditions. When the running time is too long, the insulating film on the enameled wire of the coil is dissolved, causing a short circuit between the enameled wires and burning the motor.2 When Running at Low Speed: For DC motors, carbon brushes

• Using all metal gears, come with small size, large torsion, ultra‑quiet, stable operation, very practical
• The stator and rotor adopt pure copper coils to increase the torsion of the motor, and the deceleration resistance and conductivity are strengthened
• This brushless motor will automatically cut off the power when the current reaches 3A, avoid burning out during the use of the motor and increase the service life of the motor
• The lubricating oil applied to the motor gear is high‑temperature grease, come with low friction, noise reduction, and slow temperature rise
• A total of two magnets in the motor body, which have the characteristics of high remanence, high coercivity, high magnetic energy product, high performance, and high torsion